You are currently viewing a single post of this guestblog.

Click here to go back the complete page. I would be glad to hear your comments, so don’t hesitate to leave me your feedback below. It will appear on the main guestblog page.

permalink:  265   posted on 16.10.2009 24:10
From Khiraly
Also I need libode1-dev, if not make fails at 99%. Pretty annoying;-)

sudo apt-get install libode0-dev

> # After downloading, in the same terminal, issue "cd freecad"
> to go to the freecad directory

"cd freecad/trunk"

I will report back, when I could successfully built.

Best regards,

First and foremost, your name:

And your message:

To publish it, just press this ...