# Hi Juank,

Hi Juank,
If your image was saved as jpg.tga, probably you specified jpg in the
filename, but blender wanted to save in tga format, so it added the .tga
extension after. Check on the render panel (F10) that your image output
format is jpg, not tga. (Tga is fine too, but jpg is easier to view!).
Check also the image size, because if you are going to print, you need a
bit more resolution than just to watch on screen. I would say, if you
are going to print an A4 size, you'll need at least something like
1600x1200 pixels. Then, re-render the image.
You cannot print directly from blender, but a jpg image is easy to print
from any other program that can view the image.